Розмірна та параметрична градація верстата з МПС

Loading...
Thumbnail Image

Date

2016

Authors

Вахніченко, Д. В.
Верхогляд, Ю. І.
Брайко, М. В.

Journal Title

Journal ISSN

Volume Title

Publisher

КНТУ

Abstract

В статті виконано дослідження розмірів і параметрів верстатів з механізмом паралельної структури та їх градація. Розглянуто відповідність між технічними характеристиками верстата і величиною необхідних координатних рухів виконавчого органа та умови досягнення узгодженості між цими характеристиками та вимогами, що ставляться до виконання операцій. Наведено модульну будову конструкцій верстата з МПС та запропоновано визначення основних параметрів кожного модуля та їх градацію на основі стандарту. В роботі запропоновано поділ верстатів з механізмами паралельної структури по максимальним координатним рухам, опираючись на переважні ряди чисел, основний та додатковий. Запропоновано градація верстатів за величиною кута обертання ланок в опорах платформ та по максимальному куту, під яким можлива обробка. Також представлено регламентовані параметри для лінійних розмірів, діаметрів рухомої та нерухомої платформ, відстані між їх опорами, розміру виконавчого органа та габаритних розміри несучої системи верстата. The paper used to study the size and parameters of machines with the mechanism of parallel structure and grading. We consider the correspondence between the technical characteristics of the machine and the size of the necessary co-ordinate the movements of the executive body and achieving coherence between these characteristics and the requirements of the procedures. Powered by a modular structure of the machine design with the MPS and the suggested definition of the basic parameters of each module and their graduation on the basis of the standard. The paper suggested the division of machines with parallel structure mechanisms with the maximum coordinate movements. And it is determined that most of them are the same as the next primary R20 numbers with ratio of 1.12. For these and other conditions, it is advisable to have an extra row with finer gradations, which, in accordance with GOST R40 must meet a number with a denominator 1,06. Tak for further recommendations when selecting certain parameters, preference should be given to the main or first additional row. Achieved a justification of key design parameters of MPS machines can be used as the basis of the standard. As a result, it is proposed grading machines largest units in the rotation angle of platforms and supports the maximum angle at which can be processed. Also presented regulated parameters of the linear sizes, diameters mobile and fixed platforms, the distance between their legs, the size of the executive body and the overall dimensions of the machine carrier system.

Description

Keywords

верстат, гексапод, МПС, верстат з МПС, верстат з механізмом паралельної структури, machine, hexapod, PKM, machinetool MPS, machine of parallel structure

Citation

Вахніченко, Д. В. Розмірна та параметрична градація верстата з МПС / Д. В. Вахніченко, Ю. І. Верхогляд, М. В. Брайко // Конструювання, виробництво та експлуатація сільськогосподарських машин : загальнодерж. міжвід. наук.-техн. зб. - Кропивницький : КНТУ, 2016. - Вип. 46. - С. 207-212.