Збірники наукових праць ЦНТУ
Permanent URI for this communityhttps://dspace.kntu.kr.ua/handle/123456789/1
Browse
4 results
Search Results
Item Визначення оптимальної точки приєднання сонячної електростанції до електричної мережі методом комп’ютерного імітаційного моделювання(ЦНТУ, 2023) Плєшков, П. Г.; Зінзура, В. В.; Плєшков, С. П.; Солдатенко, В. П.; Plieshkov, Р.; Zinzura, V.; Plieshkov, S.; Soldatenko, V.Метою даного дослідження є мінімізація негативного впливу сонячної електростанції на значення усталеного відхилення напруги та рівень втрат електроенергії шляхом визначення оптимального місця її приєднання до розподільної електричної мережі. В роботі для вирішення задачі оптимального розміщення відновлюваних джерел електроенергії в електричних мережах пропонується застосовувати метод комп’ютерного імітаційного моделювання. Розроблені комп’ютерні імітаційні моделі розподільної електричної мережі з сонячною електростанцією, які дали змогу визначити оптимальне місце приєднання сонячної електростанції виходячи із значень величини втрат потужності в елементах електричної мережі на рівень усталеного відхилення напруги. Результати комп’ютерного моделювання електричної мережі з сонячною електростанцією підтвердили необхідність врахування не лише значень усталеного відхилення напруги, але і величини втрат електричної енергії в елементах мережі в процесі вибору місця встановлення сонячної електростанції. The purpose of this study is to minimize the negative impact of the solar power plant on the value of the steady voltage deviation and the level of electricity losses by determining the optimal place for its connection to the distribution network. Currently, quite a large number of methods of optimal placement of renewable sources of electricity in electrical networks have been developed. However, most of them either do not fully take into account the multifunctional influence of renewable energy sources on the parameters of the electric network regime, or are quite difficult to use. In order to solve the problem of optimal placement of renewable sources of electricity in electric networks, it is proposed to use the method of computer simulation modeling. The essence of this method is to determine the optimal place for connecting a renewable energy source to the electrical network based on the analysis of the results of computer simulation modeling of network mode parameters. This approach is the most acceptable in the case of connecting a solar power plant of average power to the electrical network of an industrial enterprise. The developed computer simulation model of a distribution electric network with a solar power plant allows for the research of network mode parameters, including the determination of the level of active power loss in network elements and the level of steady voltage deviation. The specified computer simulation models of the distribution electric network with a solar power plant made it possible to determine the optimal place for connecting the solar power plant based on the values of power losses in the elements of the electric network at the level of the established voltage deviation.Item Оптимальне керування режимами розподільних електричних мереж з сонячними електростанціями при несиметричному навантаженні(ЦНТУ, 2022) Саченко, А. І.; Плєшков, С. П.; Плєшков, П. Г.; Зінзура, В. В.; Sachenko, A.; Plieshkov, S.; Plieshkov, P.; Zinzura, V.Робота присвячена удосконаленню системи автоматичного керування режимами роботи розподільних електричних мереж, що містять сонячні електростанції з метою досягнення одночасного зниження рівнів усталеного відхилення напруги, несиметрії напруг на затискачах електроспоживачів за умови максимізації рівня генерації електроенергії сонячною електростанцією. Показано, що таку задачу автоматичного керування найдоцільніше інтерпретувати як задачу багатокритеріальної оптимізації. Обґрунтовано метод вирішення цієї задачі багатокритеріальної оптимізації. Розв’язки зазначеної задачі багатокритеріальної оптимізації можуть бути покладені в основу роботи оптимальної системи автоматичного керування параметрами режиму розподільних електричних мереж, що містять сонячні електростанції. The article is devoted to improving the system of automatic control of modes of distribution electric networks containing solar power plants in order to achieve a simultaneous reduction of steady-state voltage deviations, voltage asymmetry at the terminals of consumers while maximizing the level of electricity generation by solar power plants. Ensuring normal permissible levels of electricity quality indicators in distribution networks is one of the most pressing issues that arise in the design and operation of modern distribution networks. Deterioration of the quality of electricity in electrical networks leads to the appearance of such negative phenomena, increase in additional losses in the elements of the electrical network, reduce the service life of electrical equipment, reduce the productivity of production equipment and others. The most significant negative impact on the functioning of the elements of electrical distribution networks, including electricity consumers, is observed with increasing levels of steady-state deviation and voltage asymmetry above the normative values. Modern solar inverters allow you to control the level of steady voltage deviation at the point of their connection to the mains. The design features of the construction of inverters of solar power plants allow them to change (within certain limits) not only the level of steady-state voltage deviation, but also to affect the level of voltage asymmetry and the parameters of the reactive power mode. In view of this, the task of improving automatic control systems for the distribution of electric networks with solar power plants, the implementation of which will take into account the multifunctional influence of solar inverters on the parameters of these networks is quite relevant. For the research, a fragment of a typical distribution electrical network with a nominal voltage of 10 kV was used, which contains a solar power plant that connects directly to the 10 kV busbars. The authors of the article set the problem of controlling the parameters of the mode of distribution electric network with solar power plants in the form of the problem of multicriteria optimization. An approach to solving this problem is also proposed, which is based on the method of solving problems of multicriteria optimization by approaching the utopian point in the space of criteria. Approximate calculations are carried out, which confirm the possibility of applying the proposed approach to the construction of systems for automatic control of the parameters of the mode of distribution electrical networks with solar power plants.Item Технічна реалізація системи автоматичного управління режимом низьковольтної розподільчої електричної мережі з відновлюваними джерелами енергії(ЦНТУ, 2019) Солдатенко, В. П.; Зінзура, В. В.; Плєшков, С. П.; Гарасьова, Н. Ю.; Величко, Т. В.; Зинзура, В. В.; Плешков, С. П.; Гарасева, Н. Ю.; Soldatenko, V.; Zinzura, V.; Plieshkov, S.; Harasova, N.; Velychko, T.Здійснено розробку мікроконтролерного блоку автоматичного управління режимом генерації активної потужності установок з відновлюваними джерелами енергії, що працюють в складі комбінованої електроенергетичної системи. Розроблено структурну та принципові схеми даного блоку, які було використано для створення макету пристрою. Проведено експериментальні дослідження розробленої мікроконтролерної системи автоматичного управління, результати яких підтвердили її працездатність. Произведена разработка микроконтроллерного блока автоматического управления режимом генерации активной мощности установок с возобновляемыми источниками энергии, работающих в составе комбинированной электроэнергетической системы. Разработана структурная и принципиальные схемы данного блока, которые были использованы для создания макета устройства. Проведены экспериментальные исследования разработанной микроконтроллерной системы автоматического управления, результаты которых подтвердили ее работоспособность. The purpose of the study is to develop a microprocessor-based automatic control system, the application of which will provide the highest possible level of generation of active power to the units of RES, which are part of the EEC, subject to the observance of the normally acceptable values of the established voltage deviation at the point of connection of consumers to the electrical distribution network. A block diagram of a microprocessor-based automatic control system for generating the active power of renewable energy sources operating within a combined power system using a modern element base has been developed. Structural and schematic diagrams of the microprocessor-based automatic control system were developed, based on an algorithm for determining the optimal control vector based on the solutions of the multicriteria optimization problem. The developed laboratory stand for the experimental study of the quality of work of the automatic control system of generation of active power of renewable energy sources working in the combined electric power system allowed to perform the experimental researches of the microprocessor automatic control system. Experimental studies were conducted to test the performance of the developed microprocessor-based system for automatic control of the level of active power generation, as well as to determine its efficiency. Comparison of the results of the experimental studies with the data of computer simulation and the results of statistical data showed the correctness of the theoretical studies and the efficiency of the developed system of automatic control of the generation of active power of renewable energy sources operating in the combined electricity system.Item Принципи побудови моделі дослідження втрат активної потужності в асинхронному електродвигуні(ЦНТУ, 2017) Телюта, Р. В.; Плєшков, С. П.; Teliuta, R.; Plieshkov, S.Представити принципипобудови моделі експериментального дослідження втрат активної потужності в асинхронному електродвигуні. В роботі запропонована методика дослідження втрат активної потужності в асинхронному електродвигуні з короткозамкненим ротором у функції активної потужності, яка передається з валу електродвигуна робочій машині. Втрати активної потужності в електродвигуні знаходились як різниця активної потужності яку споживав електродвигун і потужності яка передавалась на вал електродвигуна. Перша потужність вимірювалась за допомогою комплекту контрольно-вимірювальних приладів, друга розраховувалась аналітичним шляхом за допомогою параметрів Г – подібної схеми заміщення однієї фази асинхронного електродвигуна з урахуванням росту активного опору обмотки при нагріванні та виміряного ковзання. Запропонована методика дослідження втрат активної потужності в асинхронному електродвигуні дозволила встановити, що відхилення експериментальних даних від аналітичних розрахунків знаходяться в межах ±5,88%. The principles ofresearch model constructionfor active-power losses in an asynchronous electric motor is shown in the article. In process, the offered methodology of research of active-power losses is in an asynchronous electric motor with a short-circuited rotor in the function of active-power, that were transmitted to from the billow of electric motor the working machine. Losses of active-power in an electric motor calculated as a difference of active-power, which consumed by an electric motor and transmitted power on the billow of electric motor. The first power measured by complete set of control and measuring devices, the second calculated in analytical way by means of parameters of G - similar substituting chart for one phase of asynchronous electric motor taking into account the height of pure resistance of puttee at heating and measured sliding. The offered methodology of research of active-power losses in an asynchronous electric motor allowed setting that deviations of experimental data from analytical calculations are within the limits of ±5,88 %.