Збірники наукових праць ЦНТУ
Permanent URI for this communityhttps://dspace.kntu.kr.ua/handle/123456789/1
Browse
2 results
Search Results
Item Анализ теоретических исследований пульсации мгновенной подачи шестеренного насоса(КНТУ, 2013) Кулешков, Ю. В.; Руденко, Т. В.; Красота, М. В.; Кулешкова, К. Ю.; Кулєшков, Ю. В.; Кулєшкова, К. Ю.; Kuleshkov, Yuriy; Rudenko, Tatyana; Krasota, Mikhail; Kuleshkova, KatyaВ статье представлены результаты анализа теоретических исследований пульсации мгновенной подачи и давления в процессе рабочего цикла подачи шестеренного насоса. В статті представлені результати аналізу теоретичних досліджень пульсації миттєвої подачі і тиску в процесі робочого циклу подачі шестеренного насоса. The purpose of research is the analysis of the known theoretical studies devoted to reducing ripple instantaneous flow and pressure gear pumps. Analysis of the publications on the study instantaneous flow pulsation, showed an extremely wide range of variation of degree of uneven flow - from 1.25% to 73%. The results showed that the available scientific information on the work of an instant surge flow and pressure are contradictory and indicate that the developed physical and mathematical model of the process instantaneous flow gear pump is unable to fully explain the phenomenon of pulsation. It is a deterrent to further improve the design of pump and includes a comparative analysis of the results of theoretical and experimental data and on the basis of the new in-depth theoretical and experimental studies of the process fluid supply in gear pumps.Item Інформаційно-комп’ютерна система контролю процесу фрезерування деревообробного верстата(КНТУ, 2014) Руденко, Т. Г.; Єрмолаєв, Ю. О.; Rudenko, Tatyana; Yermolaev, YuriyСтаття присвячена побудові системи контролю параметрів динамічного стану деревообробного поздовжньо-фрезерного верстата. З аналізу досліджень і публікацій встановлено, що важливими інформативними параметрами є вібрація, завантаження приводів фрези та подачі заготовки, шорсткість обробленої поверхні. В роботі визначені допустимі граничні значення вище вказаних параметрів, наведено структурну схему системи контролю та програмний алгоритм роботи мікроконтролера. Article is devoted to the construction of the control system of the dynamic state of woodworking milling machines. The analysis showed that the vibration, loading of milling cutter’s drives and feed drive of billet, surface finish are the important informative parameters. In this paper the permissible limit values of the above parameters were defined, a block diagram of the control system was built, algorithm of microcontroller's work was shown . The developed control system will improve the function of the machine without changing its structure, avoid overloading the engine, unbalancing mechanical parts of the machine, prevent the appearance of defective items and get the products specified quality.