Збірники наукових праць ЦНТУ
Permanent URI for this communityhttps://dspace.kntu.kr.ua/handle/123456789/1
Browse
4 results
Search Results
Item Теоретичне обґрунтування вибору типу вітродвигуна для фермерських та індивідуальних господарств(КНТУ, 2012) Кондратець, В. О.; Мацуй, А. М.; Жесан, Р. В.; Сербул, О. М.; Kondratec, V.; Macuy, A.; Zhesan, R.; Serbul, A.У статті приведені результати теоретичного обґрунтування вибору типу вітродвигуна для фермерських та індивідуальних господарств. Показано, що у вітродвигунів з двома, трьома та чотирма лопатями на великих висотах не виникають навантаження, прикладені до кінця вала і підшипників. Вітродвигуни за умов фермерських та індивідуальних господарств працюють на висотах до 30 м, де епюра швидкості вітру нерівномірна. Встановлено, що у дволопатевому вітродвигуні за таких умов виникають ударні навантаження, ці характеристики ще гірші у чотирилопатевих вітродвигунів. Трилопатевий вітродвигун має найкращі характеристики і його слід рекомендувати для роботи на порівняно невеликих висотах. In the article the results of theoretical ground of typeselection windengine are resulted for farmer and individual economies. It is rotined that at windengines with two, three and four blades on large heights are not loadings, attached by the end of billow and to bearings. Windengines in the conditions of farmer and individual economies work on heights a to 30 m, where the epure of speeds of wind is uneven. It is set that in a twoblade windengine there are the shock loadings in these terms, these descriptions yet worse in fourblade windengine. Trilobate a windengine has the best descriptions and it must be recommended for work on comparatively small heights.Item Теоретичне дослідження розрідження пісків односпірального класифікатора джерелом з незмінною витратою води(КНТУ, 2013) Кондратець, В. О.; Сербул, О. М.; Kondratets, V.; Serbul, A.Приведені результати теоретичного дослідження розрідження пісків односпірального класифікатора джерелом з незмінною витратою води. Встановлено, що, враховуючи особливості роботи технологічної схеми, можливо застосувати джерело подачі води у пісковий жолоб класифікатора з незмінною і обґрунтованою продуктивністю. The aim is to establish the possibility of filing a constant flow of water in a sand trough classifier with stabilization diluting the slurry in a ball mill that grinds the sand with the base ore. The possibility of stabilizing the flow of water in the gutter sand one scroll classifier with stabilization diluting the slurry in a ball mill that grinds the sand along with the base ore. Using the proposed approach and analytical expressions can in almost any operating conditions justify the fixed cost of water in the gutter sand one scroll classifier, where a broad range of flow ore ball mill, its density and the circulating load for reliable transport of slurry and liquefaction of production vessels. The implementation of this approach to improve the accuracy of identification ratio ore/water in a ball mill by eliminating transaction flow measurement in sand trough and effect of the transport delay.Item Підвищення точності стохастичної САР розрідження пульпи в млинах з циркулюючим навантаженням фільтруванням сигналів(КНТУ, 2010) Кондратець, В. О.; Сербул, О. М.; Kondratec, V.; Serbul, A.Однією з основних складових системи автоматичного регулювання розрідження пульпи в кульових млинах з циркулюючим навантаженням є блок ідентифікації співвідношення руда/вода, на вхід якого подається шість параметрів (вологовміст пісків класифікатора, густина руди, витрата води в пісковий жолоб, витрата води в млин, об’ємна витрата пульпи в пісковому жолобі, масова витрата руди в кульовий млин), а на виході формується одна величина – співвідношення руда/вода. Даний блок слугує інформаційним засобом в системі, що розглядається. Перші чотири вхідні величини практично є постійними при ідентифікації, а дві останні являють собою випадкові процеси. Це приводить до похибок при ідентифікації вихідної величини. Зменшити похибку ідентифікації до мінімуму можливо фільтрацією цих випадкових процесів. Встановлено, що необхідно застосовувати цифрову фільтрацію. В якості алгоритму фільтрації слід вибрати розрахунок середнього значення випадкового процесу. Доведено, що сигнал витратоміра пульпи у пісковому жолобі необхідно фільтрувати впродовж 10 с або 20 с, 30 с і т.д., а витратоміра руди – впродовж не менше 2 с з можливістю збільшення часового інтервалу до 4 с, 6 с і т.д. One of the basic constituents of the system of automatic control of dilution of pulp in ball mills with the circulatory loading there is a block of authentication of correlation ore/water, on the entrance of which six parameters (contents of moisture of sands of classifier, closeness of ore, expense of water in a sand chute, expense of water in a mill, volume expense of pulp in a sand chute, mass expense of ore in a ball mill) are given, and on an output one parameter is formed – this is correlation ore/water. This block serves as an informative mean in the considered system. First four entrance parameters practically are permanent in the process of authentication, and two other are casual processes. It results in errors during authentication of output parameter. To decrease the error of authentication to the minimum value possibly by filtration of these casual processes. It is set that it is necessary to apply digital filtration. As an algorithm of filtration it is necessary to choose the calculation of mean value of casual process. It is well-proven that signal of expense measure of pulp in a sand chute it is necessary to filter during 10 s or 20 s, 30 s et cetera, and expense measure of ore – on a temporal segment no less than 2 s with possibility of increase of duration of sentinel interval to 4 s, 6 s et cetera.Item Теоретичне дослідження динаміки САР розрідження пульпи в млинах з циркулюючим навантаженням(КНТУ, 2011) Кондратець, В. О.; Сербул, О. М.; Kondratets, V.; Serbul, A.В статті приведені результати теоретичних досліджень динаміки системи автоматичного регулювання розрідження пульпи в млинах з циркулюючим навантаженням. Показано, що розроблена система є стійкою при вибраних параметрах лінійної та нелінійної частини, автоколивання в якій не можливі. Запропонований ідеальний релейний елемент, що може спрацьовувати і відпускати при різниці в сигналах всього на 1,0 % від заданого значення співвідношення руда/вода, забезпечує високу якість автоматичного регулювання. Система забезпечує найкращу якість при максимально можливому в ній передавальному відношенні редуктора виконавчого механізму, що дорівнює 0,02. In the article are рresented results over of theoretical researches of dynamics the system of automatic control dilution of pulp in mills with the circulatory loading. It is shown that the worked out system is steady at the chosen parameters of linear and nonlinear part, self-excited oscillations in which are impossible. The offered ideal relay element which can work and release at a difference in signals only on 1,0 % from the set value of correlation ore/water, provides high quality of automatic control. The system provides the best quality at the maximally possible in her transmission relation of reducing gear of executive mechanism which is evened 0,02.