Збірники наукових праць ЦНТУ
Permanent URI for this communityhttps://dspace.kntu.kr.ua/handle/123456789/1
Browse
2 results
Search Results
Item Визначення оптимальної точки приєднання сонячної електростанції до електричної мережі методом комп’ютерного імітаційного моделювання(ЦНТУ, 2023) Плєшков, П. Г.; Зінзура, В. В.; Плєшков, С. П.; Солдатенко, В. П.; Plieshkov, Р.; Zinzura, V.; Plieshkov, S.; Soldatenko, V.Метою даного дослідження є мінімізація негативного впливу сонячної електростанції на значення усталеного відхилення напруги та рівень втрат електроенергії шляхом визначення оптимального місця її приєднання до розподільної електричної мережі. В роботі для вирішення задачі оптимального розміщення відновлюваних джерел електроенергії в електричних мережах пропонується застосовувати метод комп’ютерного імітаційного моделювання. Розроблені комп’ютерні імітаційні моделі розподільної електричної мережі з сонячною електростанцією, які дали змогу визначити оптимальне місце приєднання сонячної електростанції виходячи із значень величини втрат потужності в елементах електричної мережі на рівень усталеного відхилення напруги. Результати комп’ютерного моделювання електричної мережі з сонячною електростанцією підтвердили необхідність врахування не лише значень усталеного відхилення напруги, але і величини втрат електричної енергії в елементах мережі в процесі вибору місця встановлення сонячної електростанції. The purpose of this study is to minimize the negative impact of the solar power plant on the value of the steady voltage deviation and the level of electricity losses by determining the optimal place for its connection to the distribution network. Currently, quite a large number of methods of optimal placement of renewable sources of electricity in electrical networks have been developed. However, most of them either do not fully take into account the multifunctional influence of renewable energy sources on the parameters of the electric network regime, or are quite difficult to use. In order to solve the problem of optimal placement of renewable sources of electricity in electric networks, it is proposed to use the method of computer simulation modeling. The essence of this method is to determine the optimal place for connecting a renewable energy source to the electrical network based on the analysis of the results of computer simulation modeling of network mode parameters. This approach is the most acceptable in the case of connecting a solar power plant of average power to the electrical network of an industrial enterprise. The developed computer simulation model of a distribution electric network with a solar power plant allows for the research of network mode parameters, including the determination of the level of active power loss in network elements and the level of steady voltage deviation. The specified computer simulation models of the distribution electric network with a solar power plant made it possible to determine the optimal place for connecting the solar power plant based on the values of power losses in the elements of the electric network at the level of the established voltage deviation.Item Проблема надійності водопровідних мереж на прикладі міста Кропивницького(ЦНТУ, 2021) Клименко, В. В.; Ковальчук, Н. В.; Гуцул, В. І.; Телюта, Р. В.; Klymenko, V.; Kovalchuk, N.; Hutsul, V.; Teliuta, R.В статті проаналізовано причини аварій та витоків на водопровідних трубах розподільчої мережі м. Кропивницького та обраховано статистичні дані експлуатаційної організації по аварійним ситуаціям при експлуатації трубопроводів діаметром від 25 до 1100 мм протягом останніх п’яти років. Встановлено, що основними видами пошкоджень труб водопровідної мережі є : наскрізні свищі сталевих труб – 54,4%; корозія сталевих труб – 25,6%; розчеканка стиків чавунних труб – 9,7%, переломи та тріщини чавунних труб – 6,1%; тріщини на стиках пластикових труб та інші – 4,2%. Отримано аналітичні залежності середнього значення параметра потоку відмов трубопроводу ω0ср від діаметра труб D та підтверджено тенденцію зменшення ω0ср при збільшенні D. Рекомендовано для підвищення надійності водопровідних мереж проводити заміну 2% мережі на рік та використовувати пластикові труби. Для зменшення ω0ср, зокрема на ділянках труб з понаднормовим терміном експлуатації, показана доцільність установлення парціально безпосередньо в трубопровід водоповітряних гасників коливань тиску, в яких відбувається поступове і повне гасіння ударної хвилі. The article presents the analysis of statistical data of the causes of breakages and leaks in water pipes of the distribution network of Kropyvnytskyi. Breakage statistics for pipelines with a diameter of 25 to 1100 mm during the last five years were calculated. As a result of segmental analysis, it was found that the main types of damage to the pipes of water supply system are through fistulas of steel pipes – 54.4% and corrosion – 25.6%; loss of integrity of cast iron pipes on joints – 9.7%, fractures and cracks of cast iron pipes – 6.1%; fractures in joints of polyethylene pipes and other damages – 4.2%. To characterize the reliability of the municipal water supply networks, the pipeline failure flow parameter ω was used. It was defined as the ratio of the number of failures of the water supply network section to the observation period and the length of pipe network sections of the corresponding diameter. The calculation of interval estimates for the failure rate parameter ωо for steel and cast iron pipes of the water distribution network of Kropyvnytskyi was carried out. According to the operational organization 84% of the network was laid using these pipes and analytical expressions were obtained to determine average values of ω0ср depending on their diameter. Significantly higher values of ω0ср were noted in comparison with similar ones given in the literature for other cities, which can be explained by a significant excess of the standard service life of 85% of steel and 50% of cast iron pipes in the water supply network of Kropyvnytskyi. To increase the reliability of water supply networks, it is recommended to implement the experience of European countries and replace 2% of the network per year and use polyethylene pipes. To reduce the failure factor of water supply networks, particularly in those areas where overtime pipes are used, the expediency of partial installation of water-air dampers for pressure fluctuations directly in the pipeline, in which there is a gradual and complete damping of the shock wave. Approbation of a prototype of a hydraulic shock absorber of this design was carried out in the hydraulics laboratory at Central Ukrainian National Technical University and its efficiency and high efficiency at full shock wave damping was confirmed.