Конструювання, виробництво та експлуатація сільськогосподарських машин. Загальнодержавний міжвідомчий науково-технічний збірник.
Permanent URI for this communityhttps://dspace.kntu.kr.ua/handle/123456789/19
Ідентифікатор медіа: R30-03925 (рішення Національної ради України від 25.04.2024 р. № 1418).
Мови видання: українська, російська, англійська, періодичність - один раз на рік.
Browse
5 results
Search Results
Item Експериментальні дослідження ефективності функціонування систем забезпечення мікроклімату від’ємного тиску в тваринницьких приміщеннях(ЦНТУ, 2023) Калетнік, Г. М.; Яропуд, В. М.; Kaletnik, Н.; Yaropud, V.Обґрунтування раціональної схеми системи забезпечення мікроклімату від’ємного тиску в тваринницьких приміщеннях на основі виробничих обстежень є основною метою проведених досліджень. За результатами досліджень встановлено, що для тваринницького приміщення із системою вентиляції наземного каналу забезпечується більше свіжого повітря в зоні перебування тварин, у порівняні зі стельовою системою вентиляції і системою вентиляції через стінові канали. The microclimate of livestock premises is determined by a set of physical, chemical and biological parameters inside the premises for keeping animals and is characterized by the following parameters: air temperature, internal surfaces of walls, ceilings, floors, windows, doors, and other internal structures; humidity of air, internal surfaces of walls, ceiling, floor, windows, doors, and other internal structures; the speed and direction of air flows in the locations of animals, manure, inflow and exhaust channels, windows and doors; the gas composition of the air - the concentration of carbon dioxide, ammonia, hydrogen sulfide, carbon monoxide; the presence of dust and microorganisms in the air; the intensity of natural and artificial lighting; optical radiation; the level of industrial noise, the degree of air ionization. The substantiation of the rational scheme of the negative pressure microclimate system in livestock premises on the basis of production surveys is the main goal of the conducted research. According to the results of the research, it was found that for the livestock room with the ventilation system of the ground channel, more fresh air is provided in the area where the animals are staying, in comparison with the ceiling ventilation system and the ventilation system through the wall channels. For the ground duct ventilation system and the wall duct ventilation system, the efficiency of contaminant removal was influenced by the ventilation rate, which is significantly dependent on the animal's age, weight, and outdoor temperature. For the ventilation system of the above-ground channel in production conditions, the efficiency of pollution removal decreased with an increase in the speed of the air flow in the ventilation. For the wall duct ventilation system, the efficiency of pollutant removal increased as the ventilation air flow rate increased, as the sampling point was located at the back of the room. In a room with a ceiling ventilation system, the efficiency of contaminant removal was significantly influenced by the lying behavior of animals, and a slight decrease in the efficiency of contaminant removal was observed with increasing ventilation.Item Обґрунтування режимних параметрів вібраційної машини для змішування сипких мас(ЦНТУ, 2017) Калетнік, Г. М.; Янович, В. П.; Калетник, Г. Н.; Kaletnik, G.; Yanovich, V.В статті наведено аналіз технологічних параметрів вібровідцентрового змішувача та їх вплив на кінетику процесу приготування сипких мас. Аналіз отриманих експериментальних даних дозволив встановити раціональні режимні параметри дослідної вібромашини за умови зменшення енерговитрат на організацію досліджуваного процесу. В статье приведен анализ технологических параметров виброцентробежного смесителя и влияние его технологических параметров на кинетику процесса смешивания сыпучих масс. Анализ полученных экспериментальных данных позволил установить рациональные режимные параметры разработанной вибромашины при условии уменьшения энергозатрат на организацию исследуемого процесса смешивания. The purpose of this article is to establish a range of effective modes of operation of the vibrocentrifugal mixer for the preparation of complex mixtures by conducting experimental studies of the influence of its technological parameters on the kinetics of the investigated process. For the implementation of the process of preparation of highly homogeneous floating substances, a research model of a vibrocentrifugal mixer was designed and manufactured. The proposed construction realizes the idea of combined interaction of the vibration and rotary motion of the executive body with the possibility of mixing in the fluidized state of the treated medium. In order to establish the operating parameters of the vibration center mixer, the homogeneity of the initial mixture was evaluated depending on the technological characteristics of the vibrating machine developed and the total loading capacity of the mixing chamber. As a result of experimental studies, graphical interpretations of the above-mentioned evaluation parameters were obtained, linearization of which was carried out by linear curvature filtering. The evaluation of the process of mixing the bulk material showed that the homogeneity of the product obtained during the centrifugal movement of the container with increasing frequency of rotation is significantly less than the combined vibrocentrifugal effect. The analysis of the experimental data obtained allowed establishing rational regime parameters of the experimental vibrating machine, provided that the energy consumption was reduced to the organization of the investigated process. On the basis of experimental researches, the expediency of preparation of highly dispersed mixtures was determined on condition of complex vibromechanical influence. Effective operating parameters of the developed vibrocentrifugal mixer have the following values: angular speed of the drive shaft 110 rad with c-1; frequency of rotation of the mixing chamber 70 min-1; amplitude of oscillation 2 mm; vibration acceleration of 30 m p-2. According to these parameters, the homogeneity of the mixture reaches 98%, while the energy costs for the implementation of this process are 1.25 kWh.Item Теорія процесу копіювання головок коренеплодів цукрових буряків новим копірно-роторним відокремлювачем гички(КНТУ, 2013) Калетнік, Г. М.; Булгаков, В. М.; Адамчук, В. В.; Борис, А. М.; Свірень, М. О.; Орищенко, С. Б.; Kaletnik, Grigory; Bulgakov, Vladimir; Adamchuk, Valery; Borys, A.; Sviren, Nikolay; Orischenko, SergeyРозроблено математичну модель вільних коливань при складному русі робочого елемента копірно-роторного відокремлювача гички цукрових буряків. За допомогою даної моделі досліджено процес копіювання головок коренеплодів. В результаті досліджень встановлено можливість використання даного робочого органу на швидкостях поступального руху машини 2…2,5 м/с. New mathematical model of free oscillations of the tool of the rotor device for removal of sugar beet haulm at its slave compound motion is developed. The process of effective slave motion along root crops heads is examined by means of the solution of this model on the computer. As a result the possibility of use of this tool at velocity range 2,0…2,5 m/s of a translational motion of a harvesting machine is defined.Item Сучасні проблеми землеробської механіки(КНТУ, 2013) Адамчук, В. В.; Калетнік, Г. М.; Черновол, М. І.; Булгаков, В. М.; Adamchuk, Valery; Kaletnik, Grigory; Chernovol, Mikhail; Bulgakov, VladimirРозглянуто сучасний стан розвитку землеробської механіки та в цілому агроінженерної науки і сільськогосподарського машинобудування. Визначені основні перспективи виходу з кризового становища країни у напрямках проведення фундаментальних та прикладних наукових досліджень сучасного рівня, проектних і конструкторських розробок по створенню сільськогосподарської техніки, яка б відповідала кращим світовим аналогам. The article discloses problems in the development of agricultural mechanics in present-day conditions of Ukraine. The situation in the development of agricultural mechanics, agro-engineering science and agricultural machine building on the whole was analysed. The problems which interfere with national agricultural production to have high competitiveness, machine-building in particular, were grounded. Special attention was given to integration processes “science-production”. The low level of scientific research during last years and absence of its orientation which is connected with the absence of interest from the side of producers towards scientific and research work were noted. The main prospects in overcoming crisis in Ukraine in the directions of carrying out fundamental and applied scientific research at modern level, project and design development in construction of agricultural machines which correspond to best world analogues were defined.Item Динаміка важільних механізмів сільськогосподарських машин(КНТУ, 2011) Булгаков, В. М.; Калетнік, Г. М.; Кравченко, І. Є.; Пришляк, В. М.; Bulgakov, V.; Kaletnik, G.; Kravchenko, I.; Pruchliak, V.Розроблений новий алгоритм розв'язування другої задачі динаміки важільних механізмів сільськогосподарських машин, обладнаних електроприводом. Алгоритм знаходить застосування при розрахунках плоских важільних механізмів стаціонарних сільськогосподарських машин. The simple algorithm of decision of the second task of dynamics of lever mechanisms with electric drive is offered. An algorithm finds application at the calculations of flat lever mechanisms.