Конструювання, виробництво та експлуатація сільськогосподарських машин. Загальнодержавний міжвідомчий науково-технічний збірник.
Permanent URI for this communityhttps://dspace.kntu.kr.ua/handle/123456789/19
Ідентифікатор медіа: R30-03925 (рішення Національної ради України від 25.04.2024 р. № 1418).
Мови видання: українська, російська, англійська, періодичність - один раз на рік.
Browse
4 results
Search Results
Item Оцінка рівномірності розподілу та засміченості зерна при його багаторівневому введенні в пневмосепаруючий канал(ЦНТУ, 2021) Нестеренко, О. В.; Лещенко, С. М.; Васильковський, О. М.; Петренко, Д. І.; Nesterenko, O.; Leshchenko, S.; Vasylkovskyi, O.; Petrenko, D.Одним із важливих показників ефективності роботи пневмосепаруючих каналів є рівномірність поля швидкостей повітряного потоку, яка в свою чергу залежить від розподілу зернового матеріалу в робочій зоні сепарації. В статті приведені результати розподілу зернового матеріалу при багаторівневому способі введення зерна, а також його вплив на засміченість легкими домішками по висоті пневмосепаруючого каналу. В результаті досліджень отримано залежності засміченості очищеного зерна легкими домішками від кількості задіяних рівнів живильного пристрою. The uniformity of grain distribution in a pneumatic separation channel is an important factor and it significantly affects the quality of grain cleaning. Indeed, with uneven feeding, impurities entering the pneumatic separating channel, to a large extent, are located in the middle or lower layers of grain flow, which impairs the possibility of their release into the settling chamber. Feeders are used to create a more uniform distribution of grain in the operating area of the pneumatic separating channel. They provide conditions under which grain material is fed into the air stream by a thin layer of directed jet. This feeding can significantly improve the interaction of the components of the input grain material with air, increasing the likelihood of their release, as well as minimize the contact of particles of the grain mixture, which significantly increases the efficiency of air flow. Based on the review and analysis of feeder designs, we have proposed a feeder for multi-level grain introduction. The use of such a feeder can significantly improve the quality of pneumo-separation, but there is a possibility of light impurities in the upper grain layers, which can affect the completeness of the separation of the purified grain. Experimental studies were conducted to determine the effect of multilevel introduction on the content of light impurities in the purified grain along the height of the pneumatic separation channel, as well as to analyze the distribution of grain mixture in the operating separation area. As a result of the conducted research it is determined that the number of involved levels of introduction of the feeding device influences the degree of clogging of the cleared grain, thus, uniformity of distribution of grain improves at increase in quantity of levels. In particular, when using up to 4 levels of the feeder under load qbi = 350 kg/dm·h at each level, the amount of light impurities entering the purified grain is not more than 3% of their total weight in the source material.Item Аналітичні дослідження контактного руху легких домішок у пневмосепаруючому каналі(ЦНТУ, 2017) Нестеренко, О. В.; Петренко, Д. І.; Павленко, І. І.; Лещенко, С. М.; Гончарова, С. Я.; Nesterenko, О.; Petrenko, D.; Pavlenko, I.; Leschenko, S.; Honcharova, S.Враховуючи складність та випадковість пневмосепараційного процесу, на який впливає значна кількість факторів, є необхідним вирішення наукового завдання щодо встановлення закономірностей контактної взаємодії легких домішок з зерном в зоні пневмосепарації. В статті розглянуто контактний рух легких домішок через багатошаровий зерновий потік в вертикальному пневмосепаруючому каналі (ПСК) при їх багаторівневому одношаровому введенні. Отримані теоретичні залежності, які дозволяють встановити закономірності впливу основних конструктивно-технологічних параметрів ПСК на якість процесу сепарації. The separation of grain materials in the air separation channel occurs in rather difficult conditions, since light impurities, which are located in the lower cereal layers for the separation into the sediment chamber, require, with a minimum change in trajectory, to cross all above-placed seed moving in a downward direction. As a result of this movement there is a contact between light impurities and grain, which significantly affects the quality of cleaning. Therefore, a very important task is the analytical research aimed at investigating the contact interaction of light impurities with grain in the air separation channel and its effect on the quality of separation. Taking into account the multilevel feeding of the material in the PSC it is necessary to determine its influence on the qualitative parameters of the separation process and the establishment of the basic laws of the interaction of light impurities with grain material in the working area of the PSC. As a result of the theoretical analysis, the regularity of the contact motion of light impurities is established at the multilevel feeding of grain material in the PSC, which allows to obtain the averaged trajectories of impurities after interaction with grain layers during aerodynamic separation. It is determined that the allocation of light impurities depends on their time and velocity through the grain layers, which vary depending on the angle of contact of impurities with grain, as well as from the place of installation of the upper point of the output of grain hɠ.ɜ.. With six-level introduction of the material with the placement of grain particles in the direction of movement in the PSC with an interval equal to their size (2R) the place of installation of the upper point of the output of grain hɠ.ɜ. must be at a height hɠ.ɜ.= 0,05 ... 0,055 m relative to the level I of the input. The purpose of further researches should be to determine the qualitative characteristics of pneumatic separation in the contact interaction of grain material with air flow at its multilevel introduction into the PSC.Item Дослідження безконтактного руху легких домішок у вертикальному пневмосепаруючому каналі(КНТУ, 2016) Нестеренко, О. В.; Лещенко, С. М.; Петренко, Д. І.; Гончарова, С. Я.; Мельник, Ю. В.; Nesterenko, О.; Leshchenko, S.; Petrenko, D.; Goncharova, S.; Melnik, Y.В статті розглянуто безконтактний рух легких частинок в вертикальному ПСК при їх багаторівневому одношаровому введенні. При прийнятих допущеннях отримані закономірності безконтактного руху легких частинок в ПСК, які дозволяють визначити раціональні параметри живильного пристрою. В результаті теоретичного аналізу визначено час перебування легких частинок в ПСК при їх безконтактному русі та зону їх виділення під час розділення зернової суміші повітряним потоком. Rational use of air flow during the separation of the grain mix is one of the main problems in pneumatic separation. Thus, it is necessary to ensure appropriate quality cleaning performance while increasing grain cleaning machines (GCM). In greater degree it concerns pneumatic GCM, who have somewhat lower rates than specific performance sieve. Therefore, improvement and development of new pneumatic structures is an important and urgent task. Taking into account the insufficient analytical scrutiny process at pneumatic separation multilayer material in grain movement pneumatic separating channel (PSC) is necessary tasks to establish patterns of airflow interaction with light impurities during their flight in contactless PSC. As a result of analytical study examined contactless movement of light impurities when entering multigrain single layer material, ie flow, in which crops are layers PSC each other with a certain interval and have the same kinematic characteristics. Based on the theoretical analysis established pattern of interaction of light particles of grain mixture with air flow during flight of contactless multi-grain placing a single layer of material in PSC. Established that the contactless movement of light impurities in the PSC, regardless of the input area of selection is in the range 0.015 ... 0.05 m, depending on their coefficient of sails. The goal of future research should be to establish contact interaction of light impurities from the grain mixture and air flow in the multilayer material placed in the PSC.Item Analytical study of separation efficiency of grain in vertical pneumatic separating channel(КНТУ, 2015) Nesterenko, Olexsandr; Leschenko, Sergey; Petrenko, Dmytro; Honcharova, Svitlana; Нестеренко, А. В.; Лещенко, С. М.; Петренко, Д. И.; Гончарова, С. Я.Taking into account the insufficient amount of theoretical research of the influence of the conditions of grain feeding into the pneumatic separating channel (PSC) on the efficiency of the process of separating grain mixture into fractions there arises a scientific task to define regularities of the interaction of the grain material with the air flow while feeding it into the vertical PSC. The movement of grain particles in a vertical PSC under onelayer feeding was considered in the article. The theoretical dependences which allow optimizing basic parameters of the PSC and defining the time of the grain in the air flow were acquired. Повітряна сепарація є одним із найпоширеніших способів очищення зернових сумішей різних культур, а пневмосепаратори набагато дешевші, простіші і надійніші в експлуатації ніж пневморешітні машини. Тому подальший розвиток конструкцій цього класу машин і вдосконалення технології сепарації повітряним потоком є актуальною і своєчасною науково-технічною проблемою. Враховуючи недостатню кількість теоретичних досліджень впливу умов введення в пневмосепаруючий канал (ПСК) на ефективність процесу розділення зернової суміші на фракції, постало наукове завдання по встановленню закономірності взаємодії зернового матеріалу з повітряним потоком при подачі до вертикального ПСК. В статті розглянуто рух зернових часток в вертикальному ПСК при їх однорівневому одношаровому введенні. Отримані теоретичні залежності, які дозволяють оптимізувати основні параметри ПСК та визначити час перебування зернової частки в повітряному потоці. Для зернової маси, що характеризується значеннями k3=0,075…0,12 – для повноцінного, k3=0,11…0,14 – для некондиційного зерна та k3=0,125…0,55 для смітних домішок, спостерігається можливість чітко розділити зернову суміш на фракції, встановивши відповідні параметри і режими роботи ПСК, а також умови введення. За рахунок підбору раціональних параметрів введення матеріалу в ПСК та встановленні відповідних аеродинамічних параметрів і режимів можливо виділити з зернової суміші до 98% легких домішок, забезпечивши при цьому мінімальні втрати повноцінного зерна у відходи. Метою подальших досліджень повинно бути встановлення взаємодії зернової суміші з повітряним потоком при багатошаровому розміщенні матеріалу в ПСК.