Конструювання, виробництво та експлуатація сільськогосподарських машин. Загальнодержавний міжвідомчий науково-технічний збірник.
Permanent URI for this communityhttps://dspace.kntu.kr.ua/handle/123456789/19
Ідентифікатор медіа: R30-03925 (рішення Національної ради України від 25.04.2024 р. № 1418).
Мови видання: українська, російська, англійська, періодичність - один раз на рік.
Browse
12 results
Search Results
Item Методика експлуатаційних досліджень зношування робочих органів дискових ґрунтообробних знарядь(КНТУ, 2009) Герук, С. М.; Борак, К. В.; Geruk, S.; Borak, K.Наведена методика експлуатаційних досліджень зношування робочих органів дискових грунтообробних знарядь. Розроблена методика дозволяє досліджувати закономірності та характер процесу зношування, динаміку зношування, вплив експлуатаційних факторів на зносостійкість та ресурс дискових робочих органів. The method of operating researches of wear of workings organs of disk soil instruments is resulted. The developed method allows to probe conformities to the law and character of process of wear, dynamics of wear, influence of experimental factors on wearproofness and resource of disk workings organs.Item Врахування реологічних властивостей ґрунтів при їх взаємодії з РОГМ(КНТУ, 2009) Аулін, В. В.; Тихий, А. А.; Aulin, V.; Tikhiy, A.В статті проведений аналіз елементів трибосистеми “грунт - робочий орган” при їх контактній взаємодії з врахуванням напружено-деформованого стану та реологічних властивостей грунту. In the article the analysis of elements is conducted tribosistemi “soil is a working organ” at their contact co-operation taking into account the tensely deformed state and reologichnikh properties of soil.Item Теоретичні дослідження процесу розподілу насіння зернових культур при підгрунтово-розкидному способі сівби(КНТУ, 2009) Рудь, А. В.; Павельчук, Ю. Ф.; Мошенко, І. О.; Rud', А.; Pavel’chuk, Yu.; Moshenko, I.На основі теоретичних досліджень процесу розподілу насіння зернових культур при підгрунтово-розкидному способі сівби визначено швидкість падіння насіння на відбивач, теоретично обгрунтовані параметри відбивача насіння та складено рівняння площин відбивача. On the theoretical basis of the seeds distribution investigation process by underground- scattered sowing method was fixed seed speed falling to the reflector, the theoretical substantiated parameters of seed reflector prism, and the technological plans of distributive ploughs means in underground-scattered seeding machines were elaborated.Item Самозагострювання робочих органів ґрунтообробних знарядь(КНТУ, 2015) Дворук, В. І.; Войтов, В. А.; Борак, К. В.; Dvoryk, Volodymyr; Voytov, Viktor; Borak, KonstantinДосліджено вплив фізико-механічних властивостей матеріалу робочого органу, абразивних властивостей ґрунтів і конструктивних параметрів робочого органу на виникнення ефекту самозагострення. Отримані уточненні умови самозагострювання для робочих органів дискових ґрунтообробних знарядь. Set conditions of independent intensifying working organ soil-cultivating instruments. Influence of mechanical properties of material working organ, abrasive properties soils, structural parameters of working organ is investigational on the origin effect of independent intensifying. Got clarification of condition of independent intensifying for the workings organs of disk soil-cultivating instruments: 1. Value thickness and hardness of the strengthening and base layer should be a lifetime condition to ensure R < Rɞ. 2. The thickness of the base layer should be as short as possible, while providing the necessary increase in strength solid layer. 3. The hardness of hardened layer should be determined in relation to the base layer hardness depending on the abrasive properties of soil. 4. Strengthening and exacerbate the line and must be subject to more intense wear that. 6. Sharpening angle must be at 28Û ... 30Û. To achieve the effect independent intensifying working organ soil-cultivating instruments must fulfill five conditions and the second and the third condition suggested by V.M. Tkachev for plowshares completely fair and intensifying working organ soil-cultivating instruments, the first condition is clarified, and 4 opposite condition is reversed.Item Дослідження зношування робочих органів дискових борін(КНТУ, 2008) Герук, С. М.; Борак, К. В.; Нечипоренко, В. О.Наведено результати досліджень зношування робочих органів дискових борін та встановлено особливості характеру їх спрацювання для вітчизняних і зарубіжних машин. It is presented results of researches of wear process of working organs of disk harrows and it is established features of character of their deterioration for domestic and foreign machines.Item Вплив ґрунту на леза робочих органів ґрунтообробних машин(КНТУ, 2015) Дудніков, А. А.; Келемеш, А. О.; Пасюта, А. Г.; Dudnikov, Anatoly; Kelemesh, Anton; Pasyuta, AndriyНаведено аналіз впливу ґрунту на ріжучі елементи робочих органів ґрунтообробних машин та розглянуто фактори, що забезпечують зниження навантажень. The article describes the main aspects of uneven wear of the blade working bodies of tillage machines. The main goal of the research is to outline the reasons that affect a higher intensity of top wear of the cutting element. Their analysis revealed the formation of compacted soil volume and its impact on the character wear top and bottom faces of the blade cultivating working body plows, cultivators, harrows difficult. Presented justification uneven wear of the front and rear faces of the blade, it is shown that under the back edge of ground friction on steel largely replaced by friction against the ground soil, which causes an increase in the coefficient of friction. The research results can be used to improve the quality of tillage, to reduce the traction effort, to increase operational stability of working bodies of tillage machines.Item Розрахунок тягових і робочих органів трубчастих скребкових конвеєрів(КНТУ, 2012) Олексишин, О.; Oleksyshyn, O.Приведена методика розрахунку робочих і тягових органів трубчастих скребкових конвеєрів. Виведені аналітичні залежності для визначення конструктивних і силових параметрів робочих і тягових органів. Дані практичні рекомендації виробництву з проектування вказаних механізмів. The design procedure of working and traction organs of the tubular chain conveyors. The derived analytical dependence for determining the design and operating parameters of power and traction bodies. Practical recommendations are expounded for production on designing these mechanisms.Item Особливості проектування ґрунтообробної техніки з урахуванням агротехнологічних і екологічних вимог(КНТУ, 2010) Корабельський, В. І.; Спірін, А. В.; Ковальова, І. М.; Korabelskiy, В.; Spirin, А.; Kovalova, І.В статті подано теоретичні дослідження, які є основою системи геометричного проектування робочих органів ґрунтообробних машин. Обґрунтовується актуальність проблеми розробки криволінійних розпушувачів для якісної обробки ґрунту з метою максимального використання його біологічної активності. Theoretical investigation, which is the base for system of tillage machine’s geometrical design it is described in this article. Urgency of the problem of curvilinear threshing machines’ designing for qualitative tillage for the purpose of maximal using soil’s biological activity is argued in this article.Item Визначення параметрів повітряного змащення робочих органів пристроїв для проколювання ґрунту(КНТУ, 2012) Хачатурян, С. Л.; Hachaturian, S.У статті сформульовано переваги використання стисненого повітря як матеріалу для змащення бокової поверхні конічних робочих органів пристроїв для проколювання ґрунту. Визначено основні параметри повітряного змащення в залежності від геометричних параметрів робочого органу та фізико-механічних властивостей ґрунту. In the article advantages of the use of the compressed air are formulated as material for greasing of lateral surface of conical workings organs of devices for the puncture of soil. The basic parameters of the air greasing are certain depending on the geometrical parameters of working organ and physical-mechanical properties of soil.Item Методика експериментальних досліджень ефективності роботи та довговічності гвинтового робочого органу транспортера(КНТУ, 2011) Куликівський, В. Л.; Kulikivskiy, V.Наведена методика експериментальних досліджень ефективності роботи і довговічності гвинтового робочого органу транспортера. Представлена лабораторна установка для проведення досліджень зі встановленими на ній необхідними пристроями, механізмами і приладами для зміни, регулювання та вимірювання конструктивно-кінематичних параметрів експериментального гвинтового транспортера. Визначені критерії оптимізації, а також фактори, що впливають на них. The method of experimental researches of work and longevity of spiral working organ of conveyer is resulted. A laboratory fluidizer is presented lead through of researches with the necessary devices mechanisms and devices set on it for a change, adjusting and measuring of structurally kinematics parameters of experimental spiral conveyer. The criteria of optimization, and also factors which influence on them, are certain.