Кафедра електротехнічних систем та енергетичного менеджменту
Permanent URI for this communityhttps://dspace.kntu.kr.ua/handle/123456789/775
Browse
Search Results
Item Temperature influence of load current of overhead electrical distribution networks in difficult weather conditions(Institute of Thermomechanics CAS, 2018) Kozlovskyi, O.; Trushakov, D.; Rendzinyak, S.; Козловський, О. А.; Трушаков, Д. В.; Рендзіняк, С. Й.In order to increase the efficiency of overhead power lines operation in distribution electrical networks under conditions of ice formation, the effect of load currents on the wires temperature of overhead lines is estimated. As a result of the analysis of daily electric loads schedule for typical agricultural consumers, it was established that during the period of the most probable formation of glaze and rime deposits their load is in the range from 11 % to 35 % relative to the daily maximum. Theoretical study of the temperature change law for the wire showed that the load currents of overhead power lines up to 25 % of the nominal value increase the wire temperature to from 0.3 ◦C to 2.2 ◦C, depending on the wind speed. When creating technical devices for implementing information systems for monitoring overhead lines in icing conditions, it is advisable to use indirect approach to control, since the wire branching to 10/0.4 kV substations of the distribution net-work temperature is similar with the ambient temperature, due to their low loading.З метою підвищення ефективності експлуатації повітряних ліній розподільних електричних мереж в умовах ожледоутворення оцінено вплив струмів навантаження на температуру проводу повітряних ліній. У результаті аналізу добових графіків електричних навантажень типових сільськогосподарських споживачів встановлено, що у період найбільш ймовірного утворення ожеледно-паморозевих відкладень їх навантаження знаходиться у межах від 11% до 35% відносно денного максимуму. Теоретичне дослідження закону зміни температури проводу показало, що струми навантажень ліній величиною до 25% від номінальної величини підвищують температуру проводу до від 0,3 до 2,2°С в залежності від швидкості вітру. При створенні технічних засобів реалізації інформаційних систем моніторингу повітряних ліній в умовах ожеледоутворення доцільно використовувати побічний підхід до контролю, оскільки температура проводу відгалужень до підстанцій 10/0,4 кВ розподільної мережі співпадає з температурою навколишнього середовища, внаслідок низького їх завантаження.Item Удосконалення вихорострумового перетворювача з П-подібним магнітопроводом з метою компенсації завад(Львівський національний університет імені Івана Франка, 2018) Трушаков, Д.; Рендзіняк, С.; Козловський, О.; Trushakov, D.; Rendzinyak, S.; Kozlovskyi, O.Розглянуто особливості взаємодії вихорострумового перетворювача (ВСП) з феромагнітним провідним середовищем при проведенні дефектоскопії феромагнітних деталей і вузлів. Запропоновано удосконалити конструкції вимірювальної системи резонансного вихорострумового дефектоскопа з трансформаторним зв’язком з двома зв’язаними вимірювальними коливальними контурами та диференціальним датчиком, який має дві вимірювальні обмотки, з метою компенсації зовнішніх завад. За результатами дослідження встановлено залежність потоку вихорових струмів від магнітного потоку первинної обмотки і властивостей контрольованого об’єкта. Показано, що трансформаторний перетворювач більш стійкий до зовнішніх факторів, оскільки вимірювальні обмотки вмикаються зустрічно і ЕРС, викликані зовнішніми факторами, взаємно компенсуються.The features of the interaction of the eddy-current transducer with the ferromagnetic conducting medium during the flaw detection of ferromagnetic components and pieces of equipment with the revealed influences of external factors such as temperature, electromagnetic interference, etc. are considered. Existing approaches do not provide a clear answer to the question of how to improve not only the accuracy of measurements, but also the ability to determine the nature of the defects of the controlled sample. The research goal is to increase the accuracy of the eddy-current control by compensating of external interferences. The improvement of the construction of the measuring system of the resonance eddy-current flaw detector with a transformer connection with two connected measuring oscillatory circuits and a differential sensor having two measuring coil blocks is proposed. These design changes practically do not affect the ability of the eddy-current flaw detector to detect defects of different types and do not reduce its sensitivity to the anisotropy of the properties of the controlled sample or the gap between the transducer sensor and the controlled product. This takes on special significance for the eddy-current flaw detectors, the basis of which is the resonance method of tracking from the effect of the gap, when the resonance frequency and the quality factor of the measuring oscillatory circuit are monitored. According to the results of the research, the dependence of the eddy-currents flux on the magnetic flux of the primary coil and the properties of the controlled sample was established. It is shown that the transformer transducer is more resistant to external factors, since the measuring coils are back-to-back connected and EMF, caused by external factors, are mutually compensating.