Збірники наукових праць ЦНТУ
Permanent URI for this communityhttps://dspace.kntu.kr.ua/handle/123456789/1
Browse
4 results
Search Results
Item Areas of Improvement of Feeding Devices for Pneumatic Separation Channels(ЦНТУ, 2023) Nesterenko, О.; Vasylkovskyi, О.; Kisilov, R.; Нестеренко, О. В.; Васильковський, О. М.; Кісільов, Р. В.Despite a significant degree of improvement of modern pneumatic separators, the method of feeding grain material into the channel remains an important issue today. The article provides an overview of feeding devices, their classification, and the design which is aimed at improving the interaction of the grain mixture with the air flow in the working area of separation. Promising directions for improving feeding devices of vertical pneumatic separating channels are outlined. On the basis of the review, the importance of practical application of additional technical means that contribute to the layering of the grain mixture both before entering and in the working area of the pneumatic separation channel is determined. Із підвищенням питомого навантаження та збільшенням товщини зернового матеріалупри пневмосепарації суттєво ускладнюється виділення легких домішок. Такі домішки розташовуються як правило, в середніх або в нижніх шарах зернового струменя, що значно погіршує можливість їх подальшого виділення в осадову камеру. За таких умов в пневмосепаруючому каналі спостерігається погіршення структури поля швидкостей повітряного потоку та знижуються показники якості пневмосепарації. Для підвищення ефективності сепарації зернового матеріалу, особливо підвищеної вологості та засміченості необхідно створити такі умови, при яких зерновий матеріал буде максимально рівномірно розташовуватись в зоні сепарації, а всі компоненти суміші будуть мати однакові умови для ефективного розділення. Одним із способів вирішення цієї задачі є застосування живильних пристроїв пневмосепаруючих каналів. Такі пристрої повинні забезпечувати умови, при яких подача зернового матеріалу в повітряний потік буде відбуватись тонким шаром. Це дозволяє значно покращити взаємодію компонентів зернової суміші з повітряним потоком, покращуючи умови розділення, а також суттєво зменшити їх зіштовхування. Тому, створивши такі умови сепарації та досягнувши рівномірної подачі зернового матеріалу, можна отримати значно вирівняне поле швидкостей повітряного потоку в робочій зоні сепарації, підвищити якісні показники та загальну технологічну ефективність роботи сепаратора. Використання різних типів живильників має свої переваги та недоліки основних типів живильних пристрої. Але основним недоліком всіх активних живильників, в тому числі аераційних, є необхідність додаткового енергоживлення. При цьому, найбільш широкого застосування набули гравітаційні живильники завдяки їх простоті та надійності конструкції. Одним з перспективних напрямків інтенсифікації процесу сепарації є використання живильних пристроїв з розшаруванням зернового потоку в вертикальній площині. Конструктивна простота деяких гравітаційних живильних пристроїв дає можливість їх встановлення при розробці нових та вдосконаленні існуючих зерноочисних машин. Це дасть змогу підвищити як ефективність роботи пневмосепарації так і економічну ефективність при використанні таких зерноочисних машин.Item Аналітичні дослідження контактного руху легких домішок у пневмосепаруючому каналі(ЦНТУ, 2017) Нестеренко, О. В.; Петренко, Д. І.; Павленко, І. І.; Лещенко, С. М.; Гончарова, С. Я.; Nesterenko, О.; Petrenko, D.; Pavlenko, I.; Leschenko, S.; Honcharova, S.Враховуючи складність та випадковість пневмосепараційного процесу, на який впливає значна кількість факторів, є необхідним вирішення наукового завдання щодо встановлення закономірностей контактної взаємодії легких домішок з зерном в зоні пневмосепарації. В статті розглянуто контактний рух легких домішок через багатошаровий зерновий потік в вертикальному пневмосепаруючому каналі (ПСК) при їх багаторівневому одношаровому введенні. Отримані теоретичні залежності, які дозволяють встановити закономірності впливу основних конструктивно-технологічних параметрів ПСК на якість процесу сепарації. The separation of grain materials in the air separation channel occurs in rather difficult conditions, since light impurities, which are located in the lower cereal layers for the separation into the sediment chamber, require, with a minimum change in trajectory, to cross all above-placed seed moving in a downward direction. As a result of this movement there is a contact between light impurities and grain, which significantly affects the quality of cleaning. Therefore, a very important task is the analytical research aimed at investigating the contact interaction of light impurities with grain in the air separation channel and its effect on the quality of separation. Taking into account the multilevel feeding of the material in the PSC it is necessary to determine its influence on the qualitative parameters of the separation process and the establishment of the basic laws of the interaction of light impurities with grain material in the working area of the PSC. As a result of the theoretical analysis, the regularity of the contact motion of light impurities is established at the multilevel feeding of grain material in the PSC, which allows to obtain the averaged trajectories of impurities after interaction with grain layers during aerodynamic separation. It is determined that the allocation of light impurities depends on their time and velocity through the grain layers, which vary depending on the angle of contact of impurities with grain, as well as from the place of installation of the upper point of the output of grain hɠ.ɜ.. With six-level introduction of the material with the placement of grain particles in the direction of movement in the PSC with an interval equal to their size (2R) the place of installation of the upper point of the output of grain hɠ.ɜ. must be at a height hɠ.ɜ.= 0,05 ... 0,055 m relative to the level I of the input. The purpose of further researches should be to determine the qualitative characteristics of pneumatic separation in the contact interaction of grain material with air flow at its multilevel introduction into the PSC.Item Дослідження безконтактного руху легких домішок у вертикальному пневмосепаруючому каналі(КНТУ, 2016) Нестеренко, О. В.; Лещенко, С. М.; Петренко, Д. І.; Гончарова, С. Я.; Мельник, Ю. В.; Nesterenko, О.; Leshchenko, S.; Petrenko, D.; Goncharova, S.; Melnik, Y.В статті розглянуто безконтактний рух легких частинок в вертикальному ПСК при їх багаторівневому одношаровому введенні. При прийнятих допущеннях отримані закономірності безконтактного руху легких частинок в ПСК, які дозволяють визначити раціональні параметри живильного пристрою. В результаті теоретичного аналізу визначено час перебування легких частинок в ПСК при їх безконтактному русі та зону їх виділення під час розділення зернової суміші повітряним потоком. Rational use of air flow during the separation of the grain mix is one of the main problems in pneumatic separation. Thus, it is necessary to ensure appropriate quality cleaning performance while increasing grain cleaning machines (GCM). In greater degree it concerns pneumatic GCM, who have somewhat lower rates than specific performance sieve. Therefore, improvement and development of new pneumatic structures is an important and urgent task. Taking into account the insufficient analytical scrutiny process at pneumatic separation multilayer material in grain movement pneumatic separating channel (PSC) is necessary tasks to establish patterns of airflow interaction with light impurities during their flight in contactless PSC. As a result of analytical study examined contactless movement of light impurities when entering multigrain single layer material, ie flow, in which crops are layers PSC each other with a certain interval and have the same kinematic characteristics. Based on the theoretical analysis established pattern of interaction of light particles of grain mixture with air flow during flight of contactless multi-grain placing a single layer of material in PSC. Established that the contactless movement of light impurities in the PSC, regardless of the input area of selection is in the range 0.015 ... 0.05 m, depending on their coefficient of sails. The goal of future research should be to establish contact interaction of light impurities from the grain mixture and air flow in the multilayer material placed in the PSC.Item Перспективний напрямок інтенсифікації повітряної сепарації зерна(КНТУ, 2012) Нестеренко, О. В.; Васильковський, О. М.; Лещенко, С. М.; Петренко, Д. І.; Богатирьов, Д. В.; Nesterenko, О.; Vasilkovsky, О.; Leshchenko, S.; Petrenko, D.; Bohatyrov, D.Стаття присвячена огляду живильних пристроїв для повітряної сепарації зерна. Запропоновано перспективний напрямок інтенсифікації пневмосепарації зерна та нову конструкцію живильного пристрою пневмосепаруючого каналу (ПСК), яка дозволить підвищити продуктивність, зменшити енергоємність та покращити ефективність процесу сепарації. This article provides an overview of nutrient devices for pneumatic seed separation. Proposed promising area intensifying of for pneumatic seed separation and new construction of the device pneumatic nutrient canal, which allows to increase productivity, reduce energy capacity and increase the efficiency of the process for pneumatic seed separation.