Рідкопластичне формування поверхонь бабітових вкладишів
Вантажиться...
Файли
Дата
Автори
Ошовський, В. Я.
Григурко, І. О.
Капура, І. А.
Oshovsky, V.
Grigurko, I.
Kapura, І.
Назва журналу
ISSN журналу
Назва тому
Видавець
КНТУ
Анотація
Розглянуто рідкопластичне формування поверхонь бабітових вкладишів при безпосередньому їх
суміщенні з валом. Доведено, що це покращує збіг геометрії поверхонь їх контакту та підвищує ресурс
спряження. The defects of geometry are described for the surfaces of friction of slidewaies from a babbit, which are
used in compressors and ICE for agriculture technique.
For the increase of resource of machines it is offered to form geometry for the bearing surface of
slideway by a billow. For this purpose, surfaces from a babbit in the fluidplastic condition are offered to form by
the polished surface of neck of billow. The interval of temperatures for a surface at forming is offered on the basis
of analysis of process of crystallization of babbit. The method of heating is offered for formation of rought
tolerance for grinding in of bearing surface to the billow. The same forming is recommended to execute and for
the bronze bearings of covered preliminary by the layer of babbit. Such treatment of surface liquidates formation
on her of regions of enhanceable specific pressure.
The results of researches show that, liquidplastic forming in a complex with grinding in allows to increase
the resource of compressors or ICE of agricultural technique.
Опис
Ключові слова
вкладиші, бабіт, спряження, рідкопластичне формування, якість поверхонь, ресурс, slidewaies, babbit, connection, liquidplastic shaping, quality of surfaces, resource
Бібліографічний опис
Ошовський, В. Я. Рідкопластичне формування поверхонь бабітових вкладишів / В. Я. Ошовський, І. О. Григурко, І. А. Капура // Конструювання, виробництво та експлуатація сільськогосподарських машин: загальнодерж. міжвід. наук.-техн. зб. - Кіровоград: КНТУ, 2014. - Вип. 44. - С. 248-251.